Sweep the hard floor thoroughly – Make sure the floor is swept before you start using the cleaning machine by either sweeping it using a broom, dust mop or even Oreck Vacuum cleaner.The effectiveness of the machine depends on the concentration of the cleaning agent and ferociousness of the brushes. It will enable the machine to remove all the grease, oil, food and grime on the floor. In order to clean a hard floor, use All Purpose Concentrated Cleaner. If the carpet is too big, repeat steps 2 through 6 on the next 6×6 area until the whole carpet is super clean.Clean the soiled hat – If the bonnet is soiled, rinse it under running water to remove all the dirt and soil.After some few minutes, switch off the device and flip over the bonnet and continue. Turn on the machine – Operate the cleaning machine on the wet 6×6 area.Work the device in a forward and backward motion. Hat with Orbiter – Detach the carpet bonnet to the brush holder then place the cleaning machine onto the brush holder.Work on the sprinkled area at a time to certify the cleaner has brushed the carpet while still wet. Sprinkle – Fill the carpet cleaner half way and sprinkle over the fogged 6×6 area.Pre-mist -Wet the carpet by using Soil Realizing Pre-Spray which will mist the carpet to an area of approximately 6×6.Vacuum – Use Oreck Orbit vacuum cleaner to remove the loose dust particles on the floor.Click image to learn more Tip 5: Clean Your Dirt Carpet Use the necessary shampoo either dry or wet when cleaning.ĭifferent floors have different cleaning procedures. In case the brush is not well detached on the round pad, fix it properly. If you use the floor machine on a surface without dry shampoo or wet shampoo, it is likely to bounce. – It is either the brush or the pad holder is not appropriate in its place. If there is no source of power, check the outlet fuse and the circuit breaker. Make sure the cleaner is decisively plugged into the wall outlet. It is either you have not plugged it into the socket correctly or there is no electricity in the wall outlet. Tip 4: Avoid Common Problems that May Arise while Cleaning Your Floor Test the device when you buy it to ascertain if it is in excellent condition. It is advisable to put on shoes when using the machine. The machine’s Balanced Counter Weight System enables it to clean the floor smoothly since you can control it with fingertips. You can go over a dirt area as many times as you want until you are satisfied. The “T” handle enables you to have complete control of the machine. Tip 3: Clean the Dirt Area on Your FloorĬlench the “T” handle on the machine and glide it across the floor you want to clean in a back and forth motion. The tool should be serviced by authorized service providers or experts. Oil the bearings with light oil at the pivot points from the bondage to the housing. Orbiter machine has motor bearings that need to be periodically lubricated. Tip 2: Lubricate the Oreck Orbiter Motor Bearings Efficiently Do it politely to avoid damaging the holder pan. Lay the device on its back and pull off the brush from the round holder. If you would like to remove the brush from the machine to clean it or to replace it. Always make sure the machine motor is switched off. Make sure the brush is tightly held on the machine. Place the holder over the brush holder on the device. Lay the floor machine on its back with the handle facing on the floor. The machine is not well fitted with the brush once you buy it. Conclusion Tip 1: Attach the Drive Pad Holder Properly

Oreck orbiter pads and brushes